Navigation bar
  Print document Start Previous page
 117 of 177 
Next page End  

SAE J2735-Draft-Rev15 [issued: 01-30-07]
-
117 -
This is an SAE Motor Vehicle Council draft document of the DSRC committee, subject to change.
                 -- or other messages
                 -- two bytes in length
    } 
    -- note that typically the above is encoded as a 
    -- sequence of 37 known bytes when send over DSRC media
XML Representation:
<xs:element name="roadSideAlert" type="RoadSideAlert"/>
<xs:complexType name="RoadSideAlert" >
      <xs:annotation>
         <xs:documentation>       
            note that typically the above is encoded as a
            sequence of 37 known bytes when send over DSRC media
         </xs:documentation>
      </xs:annotation>
      <xs:sequence>
         <xs:element name="typeEvent" >
            <xs:simpleType> 
               <xs:restriction base ="itis:ITIScodes"/>
            </xs:simpleType> 
         </xs:element>
         <!-- a category and an item from that category
         all ITS stds use the same types here
         to explain the type of  the
         alert / danger / hazard involved
         two bytes in length -->
         <xs:element name="description" >
            <xs:complexType>
               <xs:sequence minOccurs="8" maxOccurs="8">
                  <xs:element name="description-item" >
                     <xs:simpleType> 
                        <xs:restriction base ="itis:ITIScodes"/>
                     </xs:simpleType> 
                  </xs:element>
                  <!-- eight ITIS code entries to further describe the event,  give advice, 
or any other ITIS codes non used positions are set to zero 16 bytes in length -->
               </xs:sequence>
            </xs:complexType>
         </xs:element>
         <xs:element name="priority" type="Priority" />
         <!-- the urgency of this message,  a relative
         degree of merit compared with other
         similar messages for this type  (not other
         message being sent by the device) ,  nor a
         priority of display urgency
         one byte in length -->
         <xs:element name="extent" type="Extent" />
         <!-- the spatial distance over which this
         message applies and should be presented
         to the driver
         one byte in length -->
         <xs:element name="spaceVector" type="SpaceVector" />
         <!-- a compact summary of the position,
         heading,  rate of speed,  etc of the
         event in question. Including stationary
         and wide area events.
         15 bytes in length -->
         <xs:element name="furtherInfoID" type="FurtherInfoID" />
         <!-- a link to any other incident
         information data that may be available
         in the normal ATIS incident description
         or other messages
         two bytes in length -->